HP Sticky Shield is the ultimate way to stop heat from radiating into the drivers compartment of your ride. Made from a dense layer of 1/8? fiberglass insulation shielded by a rugged layer of .003? thick aluminum, HP Sticky Shield may be cleaned after installation and is resistant to the elements. The heavy duty peel and stick adhesive will bond to almost any clean surface (not recommended for unfinished fiberglass or carbon). It is the perfect radiant heat shield for transmission tunnels, mufflers, catalytic converters, DPF?s, turbos, downpipes, and exhaust system heat. This HP Sticky Shield can be used with less than 1? of airspace, however when used with 1? or more airspace, it is capable of shielding over 90% of heat. Did that set of long tube headers on your Mustang, Camaro, Challenger, or tuner move your catalytic converter where there are not any factory heat shields? Use Sticky Shield to stop the heat! That Jeep getting some serious heat in the transmission tunnel or from the cat, Sticky Shield it away!
