SPC Performance .50 deg. Neg. Toe Shim-Honda - 71648

This easy to install full contact shim is specifically designed for the Internationl models of the Honda Civic Type R. The specific regions include the following years: European (2007-2008) and Asian...

SPC Performance .50 deg. NYLON CAMBER SHIM - 71731

For camber and toe change, use our Mini-Van Shims that allow for quick and easy changes in increments of: toe .10 degrees and camber .25 degrees. CAUTION:check brake and rotor clearance for binding...

SPC Performance .50 deg. NYLON CAMBER SHIM - 71752

This easy to install full contact shim is perfect for PT Cruisers needing rear camber adjustment. SPC's fixed change shim will provide +.5deg of camber change and can be stacked with up to two shims...

SPC Performance .50 deg. NYLON TOE SHIM - 71724

For camber and toe change, use our Mini-Van Shims that allow for quick and easy changes in increments of: toe .10 degrees and camber .25 degrees. CAUTION:check brake and rotor clearance for binding...

SPC Performance .50 deg. Pos. Toe Shim-Honda - 71644

This easy to install full contact shim is specifically designed for the Internationl models of the Honda Civic Type R. The specific regions include the following years: European (2007-2008) and Asian...

SPC Performance .75 deg. CAMB/TOE SHIM - 71025

These full contact rear shims will correct camber and/or toe. Combination adjustments, or changes up to 1 degree may be achieved by using 2 shims on each wheel. NOTE: Do NOT adjust Camber or Toe over...

SPC Performance .75 deg. Ford Camber Shim - 71763

This full contact rear shim adds positive 0.75deg camber to minimize camber related tire wear for 08-09 Ford Taurus and 05-07 Ford Freestyle FWD. Brake Caliper shim included for correct hub to...

SPC Performance .75 deg. NYLON CAMBER SHIM - 71732

For camber and toe change, use our Mini-Van Shims that allow for quick and easy changes in increments of: toe .10 degrees and camber .25 degrees. CAUTION:check brake and rotor clearance for binding...

SPC Performance .75 FLARED HOLE DIE - 15835

Often called "dimple dies", flared hole dies are used in sheet-metal fabrications to provide rigidity and strength to flat, unsupported panels. Due to the resulting high strength -to-weight ratio...

SPC Performance .80 deg. NYLON TOE SHIM - 71725

For camber and toe change, use our Mini-Van Shims that allow for quick and easy changes in increments of: toe .10 degrees and camber .25 degrees. CAUTION:check brake and rotor clearance for binding...

SPC Performance 0 deg. 4X4 CAM/CAS SLEEVE - 23139

Change camber,caster or both at the same time with these sleeves. Simply remove the tire, cotter pin and upper ball joint stud nut and break the taper free between the stud and sleeve. Using a sleeve...

SPC Performance 0 deg. CAMBER/CASTER SLV - 23199

These popular sleeves are widely used to adjust caster and/ or camber on many Ford and Mazda RWD & 4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring...