Rigid Industries LED Headlight PWM Pigtail Adaptor - 55006

The RIGID Anti-Flicker PWM Adaptor eliminates headlight flicker in 2007-2013 Jeep JK models. A limited number of Jeep JK users may see a flicker as a result of the PWM electrical system used on these vehicle models.

Rigid Industries 24 Volt Relay - 49024

Standard relays included with RIGID wire harnesses are 12V. If your RIGID LED light project has a 24V electrical system, you will need to replace the 12V relay with this 24V relay for proper functionality.

Rigid Industries 12V Relay - 49012

Standard relays included with RIGID wire harnesses are 12V. If your project has a 24V electrical system, you will need to replace the 12V relay with a 24V relay for proper functionality.

Rigid Industries 6 Amp LED Flasher - 2 Output - 12 Volt - 40612

This RIGID 6 amp flasher module provides seven flashing options for your LED lighting components. It is easy to install and works off of the auxiliary switch to your lights. This model features the following modes: Double Alternating: Alternates flashing...

Rigid Industries 3 Amp LED Flasher - 2 Output - 12 Volt - 40312

This RIGID 3 amp flasher module provides seven flashing options for your LED lighting components. It is easy to install and works off of the auxiliary switch to your lights. This model features the following modes: Single Simultaneous: Both sides flash...

Rigid Industries Harness Radiance Multi-Trigger - 40200

The Radiance Multi-Trigger Harness was designed specifically for the Rigid Industries? Radiance light bar. Equipped with two independent circuits for an easy install, circuit one is designed for higher amperage and utilizes a relay to power the primary...

Rigid Industries 1M Extension - Add a Light for Dually Lights - 40197

This Add-a-Light Extension gives you an additional 1 meter of length to allow for more versatility and installation options. It features 14 AWG wire and a Deutsch DT connector. This harness extension is designed to be used with SRM, SRQ, Dually, SR...

Rigid Industries Harness for pair of D2 Lights - 40196

This 14 foot/4.3 meter wiring harness is designed to connect a pair of D-Series OR SR-Q LED lights to your 12V electrical system. It features battery terminals on one end and Deutsch connectors on the other to connect to the lights. It incorporates an...

Rigid Industries Harness used for set of Dually Lights - 40195

This 14 foot/4.3 meter wiring harness is designed to connect a pair of D-Series LED lights to your 12V electrical system. It features battery terminals on one end and Deutsch connectors on the other to connect to the lights. It incorporates an inline...

Rigid Industries Harness used for 4in/ 6in/ Single Dually/ D2 - 40194

This 11 foot/3.35 meter wiring harness is designed to connect a single LED light to your 12V electrical system. It features battery terminals on one end and a Deutsch connector on the other to connect to the light. It incorporates an inline fuse holder,...

Rigid Industries Harness used for 10in-30in Light Bars - 40193

This 11 foot/3.35 meter wiring harness is designed to connect a single LED light bar to your 12V electrical system. It features battery terminals on one end and a Deutsch connector on the other to connect to the light. It incorporates an inline fuse...

Rigid Industries 25in Harness with 3 position switch use with D/ SRM or SRQ for Back up Lights - 40192

This 33 Foot/10 meter harness for your RIGID LED Lights has an easy to use three position switch: On/Off/Auto when in reverse and is used for SR-M and SR-Q Series Back Up Kits.